Dallas summers push 95-plus degrees and the humidity never really lets up, so wood fascia and soffit soak up moisture then bake dry. That cycle cracks paint and lets bugs in. I see it every week on homes in East Dallas and Lake Highlands where original wood still sits behind the gutters.
Cheap crews often just slap new paint over soft spots instead of cutting back to solid lumber. A year later the rot comes back worse. We cut to good wood, prime both sides of the new board, and use stainless nails so the coastal-style salt air from the humidity does not eat the fasteners.
Dallas code wants proper attic ventilation when you touch soffit. Blocking those vents with solid panels fails inspection and traps heat that shortens roof life. We always match the vented panels the city expects on homes built after 1980.
What usually starts as a small fascia split after a hail hit turns into full eave rot by the next mild winter. Call us at 5124 Sharp St before the drip edge lifts and water gets under the shingles.
Soffit and Fascia Repair Services We Offer
✓Soffit Repair After Hail Storm
We replace dented aluminum soffit panels on one or two sides the same day the adjuster signs off.
✓Emergency Fascia Board Fix
24/7 call-out for loose or falling fascia that lets water behind the gutter on two-story homes.
✓Wood Fascia Replacement Dallas
Cut out rotted pine or cedar fascia and install primed finger-joint or PVC on Uptown and Oak Lawn houses.
✓Vented Soffit Install
Add code-correct vented aluminum soffit so attics breathe in Deep Ellum and Bishop Arts District buildings.
✓Commercial Soffit Repair
Fix damaged soffit and fascia on small retail strips in North Dallas using 24-gauge metal that matches existing color.
Soffit and Fascia Repair Cost in Dallas, TX
| Service | Typical Range | What Affects It |
|---|---|---|
| Replace fascia on one side of house | $650–$1,400 | Wood length and whether we match existing profile. |
| Soffit panel replacement after storm | $900–$2,100 | Aluminum vented panels and access on single story. |
| Full eave repair both sides | $1,800–$3,400 | Includes new drip edge and rotted rafter tails. |
| Commercial fascia section fix | $1,200–$2,800 | Metal gauge and height of building. |
| Free estimate and written scope | Free | Call 24/7 or stop by 5124 Sharp St Mon-Sat 7am-7pm. |
Ranges are typical for Dallas, TX and confirmed with an exact written quote before any work starts.
How it works
- 1
On-site check
We walk the eaves, probe soft spots, and measure linear feet. Takes 30 to 45 minutes.
- 2
Tear off damaged sections
Remove rotted wood or dented metal without tearing shingles. One to two hours on most homes.
- 3
Install new material
Fit new fascia board or vented soffit panels and nail with stainless. Three to six hours depending on length.
- 4
Seal and clean
Caulk all joints, paint to match, haul away scraps. Final walk-through same day.
Pricing
Most jobs fall between $900 and $3,200. Bigger two-story homes or full perimeter work cost more.