Metal roofs handle Dallas heat better than shingles because the panels reflect sunlight and cut attic temps. In humid subtropical weather with hot summers the metal expands and contracts every day so we use hidden clips and screws rated for 140 degree swings. Cheap crews skip the thermal breaks and you get oil canning and leaks by the second summer.
Hail hits hard in North Dallas and East Dallas so we check for dented panels that still hold water. We carry 24 gauge and 26 gauge Galvalume stock on the truck. Most homes around the Dallas Arboretum need a permit pulled through the city before we start and that adds one day to the schedule.
We see plenty of screw-through failures on older metal roofs in Oak Lawn and Deep Ellum. The rubber washers dry out after five years and water gets under the panels. We replace them with butyl tape and oversized neoprene washers that last longer in the mild winters here.
Call 214-555-0199 for same-day metal roof leak checks. We work Mon-Sat 7am-7pm and keep a crew on call 24/7 for storm damage.
Metal Roofing Services We Offer
✓Metal Roof Repair Dallas
Fix dents and loose fasteners on standing seam roofs in two to four hours using matching 24 gauge panels.
✓Hail Damage Metal Roof Repair
Replace dented sections after storms with new Galvalume panels that match the existing color.
✓24 Hour Metal Roof Leak Repair
Emergency patch on leaking seams or flashings within four hours for homes in Uptown Dallas and Bishop Arts District.
✓Commercial Metal Roofing Installation
Install screw-down or standing seam systems on small retail buildings with 10 to 14 day lead time.
✓Metal Roof Replacement Dallas
Tear off old shingles and install new metal over solid decking in three to five days for Lake Highlands homes.
Metal Roofing Cost in Dallas, TX
| Service | Typical Range | What Affects It |
|---|---|---|
| Metal roof leak repair | $450–$950 | Depends on access and how many seams need resealing. |
| Hail dent panel replacement | $1,200–$2,800 | Varies by number of damaged panels and color match. |
| Full metal roof on 1,500 sq ft house | $12,000–$18,000 | Includes tear off, deck repair, and permit. |
| Commercial metal roof section | $4,500–$9,000 | Price changes with building height and slope. |
| Free estimate and roof inspection | Free | Call 214-555-0199 or stop by 5124 Sharp St. |
Ranges are typical for Dallas, TX and confirmed with an exact written quote before any work starts.
How it works
- 1
Site Walk and Measure
We check the deck, eaves, and penetrations then measure twice. Takes one to two hours on site.
- 2
Material Order and Permit
We pull the city permit and order panels. Lead time runs three to five days in Dallas.
- 3
Tear Off and Deck Prep
Remove old roofing, fix bad plywood, and lay ice and water shield at valleys. One day for most houses.
- 4
Panel Install and Trim
Set panels with hidden clips, seal all laps, and install ridge vent and flashings. Two days typical.
- 5
Final Walk and Cleanup
Check every seam with a water hose test and haul off all scrap. Same day finish.
Pricing
Most metal roofing jobs in Dallas run $8 to $14 per square foot installed.